NOTE:   Included with your Sprint ST windscreen are 6 stainless steel screws and 4 rubber "Well Nuts". These Well Nuts are similar to the two rubber inserts that your stock windscreen fastens to at the rear of the screen. Your stock windscreen uses 4 tabs, molded into the forward half of the screen, that insert into four slots in your fairing. In addition, two screws fasten the rear half of the screen to the fairing.

Your Zero Gravity windscreen does not use the four mounting tabs. Instead, it incorporates 6 mounting holes and is mounted to your fairing using the included Well Nuts and Stainless Steel Screws.

Mounting Your Zero Gravity Windscreen

Step One:   First remove your existing windscreen from the fairing by unscrewing the two screws at the rear of the windscreen and pulling upward and rearward on the screen to pull it out of the mounting slots.

Step Two:   Insert the four Well Nuts in the existing 4 holes in your fairing that correspond to the position of the mounting holes in your Zero Gravity windscreen.

Step Three:   Position your Zero Gravity windscreen in its place on the fairing and then insert the screws included with your windscreen into the mounting holes. Thread the screws into the Well Nuts initially just enough to keep them in place. When all 6 mounting screws are in place, tighten each screw starting with the screws closest to the headlight working your way rearward. Tighten the screws enough to cause sufficient expansion of the Well Nut to keep the windscreen snug to the fairing.

Do not over-tighten!